|25th April 2019, 05:19 AM||#1151|
Join Date: Sep 2001
Location: Melbourne, Australia
I have reworked it for best performance, but there are limitations with only 12V and a stiff 32R load. Both limitations increase the THD but the harmonic profile is still very good, with typical THD of 0.03% at 1Vpp into 32R load at 1KHz. H2 is dominant.
At 32R load you are limited to an output of about 2Vpp. At higher impedance loads, such as a 280R Beyerdynamic, your output voltage rises to 9.2Vpp, which is very loud indeed.
Your resistor divider for the input voltage reference is a little off, and you should use a bias resistor of 22k, rather than 10k, to minimise changes to the divider reference voltage.
The adjusted schem is attached. Nice circuit, sounds wonderful!
Aspen Amplifiers P/L (Australia)
|25th April 2019, 07:11 AM||#1152|
Thank you so much!
You are a master at this craft!
I will surely build it.
Thank you again.
My revamped site https://sites.google.com/site/analogdesign1234/
|Thread||Thread Starter||Forum||Replies||Last Post|
|Another DAC + Headphone amp||ghetto||Digital Source||14||10th July 2008 05:02 PM|
|ESL Headphone X-former||bjackson||Planars & Exotics||5||19th September 2005 04:45 AM|
|Headphone amp||audioPT||Headphone Systems||5||28th September 2004 09:03 PM|
|Zen v4 headphone amp||Rob M||Headphone Systems||11||21st May 2003 01:58 AM|
|Aspen Amplifiers - the ASKA 100 WATT||griff||Solid State||25||13th April 2002 04:15 PM|
|New To Site?||Need Help?|