Hello,
i want to built my ZEN revisted and the bridge line Stage.
I also want to hear with my headphone. Is this possible?
And how?
Greetings Hauke
i want to built my ZEN revisted and the bridge line Stage.
I also want to hear with my headphone. Is this possible?
And how?
Greetings Hauke
See the thread
http://www.diyaudio.com/forums/showthread.php?threadid=741
for some ideas. You can either build the amp as-is and drive the headphones through resistors, or scale the amp to drive headphones.
You could also build a separate buffer for your headphones. See http://www.headwize.com [Library\Projects] for lots of ideas.
http://www.diyaudio.com/forums/showthread.php?threadid=741
for some ideas. You can either build the amp as-is and drive the headphones through resistors, or scale the amp to drive headphones.
You could also build a separate buffer for your headphones. See http://www.headwize.com [Library\Projects] for lots of ideas.
hi, .. good idea, we (Paulb and I) have discused it else were on the forum ... a 120-120 ohm resistor in series or as voltage divider would work fine for 32 ohm headphones.. I gonna put my idea's on my webpage soon.. I'll let post a forum topic when I do...... Headwize is an excelent site!!
greetings
greetings
Hey, tschrama, thanks for the tip on Circuitmaker. I'm simulating mods to the Szekeres buffer amp, it is a lot of fun.
Headphone
Hello,
i use to hear with my Sennheiser HD 600 with 300 Ohm impedance. I think this will roll off the lower frequencies, when i connect the headphone at the bride of zen.
What about to connect at the zen amp?
Greetings from Hamburg
Hauke
Hello,
i use to hear with my Sennheiser HD 600 with 300 Ohm impedance. I think this will roll off the lower frequencies, when i connect the headphone at the bride of zen.
What about to connect at the zen amp?
Greetings from Hamburg
Hauke
You can feed the BOZ into a "Szekeres" buffer:
http://headwize.com/projects/szeke1_prj.htm
I know somebody on this forum has talked about this...
To connect to the Zen amp use a dropping resistor or divider as tschrama says.
p.s. Nice headphones you got there, Hauke.
http://headwize.com/projects/szeke1_prj.htm
I know somebody on this forum has talked about this...
To connect to the Zen amp use a dropping resistor or divider as tschrama says.
p.s. Nice headphones you got there, Hauke.
- Status
- Not open for further replies.