one last question for now...
what is the best quality cap i can get for the 1nf and 10pf on the boards? i got black gates for the 220uf value, but still looking for the other 2 values. is mica the right type? im just unfamiliar with what is good for this value and type... thanks guys!
what is the best quality cap i can get for the 1nf and 10pf on the boards? i got black gates for the 220uf value, but still looking for the other 2 values. is mica the right type? im just unfamiliar with what is good for this value and type... thanks guys!
care to explain a little bit more?
i still need the 200uf ones right? because those are ordered 🙂
ill read the post and see if i can find out what you are talking about...
i still need the 200uf ones right? because those are ordered 🙂
ill read the post and see if i can find out what you are talking about...
The amp will likely be stable without these, but for the "average" builder I suspect NP would still recommend their use.
Mica will do just fine.
Mica will do just fine.
ok, i did the reading.
however, my boards are done, im using the ones from kristijan. i already have them, and am using the design as is. so given that, which type do i use? and is there a particular brand/type that will yield best/better results?
however, my boards are done, im using the ones from kristijan. i already have them, and am using the design as is. so given that, which type do i use? and is there a particular brand/type that will yield best/better results?
- Status
- Not open for further replies.