i figured, building a Sugden A21a power amp for biamping might be nice, it should not be to difficult. but i would need the circut design since none was to be found in the small instruction leaflet, and since i dare not open my precious amp (very expensive for me indeed 🙂) if anyone has them i would be very glad to have a look...
thanks alot
thanks alot
Looking for the schema - as I want to overcome the pre-stage issues and connect directly to the volume potentiometer and then to power input, byt the schema reverse engineering goes hard - need to open too much bolts in the amp. Can somebody post the schema?
I did open mine up, the power amp atleast, wasn't too much there to reverse-engineer it. Unfortunately, i don't still have it.
- Status
- Not open for further replies.