Hi I have a technical question....
I want a single binding post input on a speaker with built in sub. I need a way to drive the preamp input on the sub amp from the speaker binding posts.
Should I use a resistor or a step down transformer? I need to not interfere with the speaker, and also need to not blow up the input board on the sub amplifier.
Anybody know of a good product for this?
I want a single binding post input on a speaker with built in sub. I need a way to drive the preamp input on the sub amp from the speaker binding posts.
Should I use a resistor or a step down transformer? I need to not interfere with the speaker, and also need to not blow up the input board on the sub amplifier.
Anybody know of a good product for this?
I think this is made to emulate a speaker's impedance. I need an output in addition to the speaker being driven.
oh and I think most of the premade car audio boxes are limited to 30 watts or so. I need to be able to handle a lot more power.
- Status
- Not open for further replies.