I have an old Rotel RA9708X amplifier with a dual volume pot, and one channel is dying on me.
The pot is marked VR501 on the print card, and 50KAX2 on itself.
Can anyone recomend a replacentpart for it, and where to buy it online?
Any help would be much apriciated!!
-Kvikkas
The pot is marked VR501 on the print card, and 50KAX2 on itself.
Can anyone recomend a replacentpart for it, and where to buy it online?
Any help would be much apriciated!!
-Kvikkas
Attachments
Maybe better to ask the question in the Solid State or parts section of the forum...
Anyway, 50KAX2 suggests an Alps pot, so just replace with a new 50k Alps pot and use wire links to connect to the circuit board.
If you are sure that the pot is faulty.
Anyway, 50KAX2 suggests an Alps pot, so just replace with a new 50k Alps pot and use wire links to connect to the circuit board.
If you are sure that the pot is faulty.
if you can't find a replacement or make one fit, if it was me I'd bypass it (set it at max with direct wires) and use an external attenuator for varying volume.
then, the sky's the limit. passive, active, cheap, expensive, you name it.
then, the sky's the limit. passive, active, cheap, expensive, you name it.
- Status
- Not open for further replies.