Hello everyone.
First of all i'am just a typical software engineer who loves car audio and almost have no experience in electronic. One of my amplifiers blown fets. That was initial story 🙂
What i have: analog scope 0-10Mhz, soldier station, couple of multimeters, cheap Chinese transistor tester.
i've replaced two power fets, four outputs. No any waveform on 8 output fets, four of them have 50v on legs. Protect led is slightly on.
Maybe somebody could provide me in my noob investigation? 🙂
First of all i'am just a typical software engineer who loves car audio and almost have no experience in electronic. One of my amplifiers blown fets. That was initial story 🙂
What i have: analog scope 0-10Mhz, soldier station, couple of multimeters, cheap Chinese transistor tester.
i've replaced two power fets, four outputs. No any waveform on 8 output fets, four of them have 50v on legs. Protect led is slightly on.
Maybe somebody could provide me in my noob investigation? 🙂
Have you read through the following thread? It's a very similar amp to yours.
Rockford Fosgate T1000bd Repair help.....
Rockford Fosgate T1000bd Repair help.....
- Status
- Not open for further replies.