I am building a pair of the BOFU TLs from the Nelson Pass plans. Can anyone suggest how much stuffing I should start with? I have read the thread from svwolfpack in which he suggests using just a little batting. Any other opinions?
Pad the sides and top with egg crate about 12"
Then tease the fiberfill as much as you can.
Lightly drop it in the cutout till it reaches the top of the cutout! That's what worked for me.
Then tease the fiberfill as much as you can.
Lightly drop it in the cutout till it reaches the top of the cutout! That's what worked for me.
Where are the Pass Bofu TL plans posted? I know that I have seen them, but now I can't find them.
What I really want to know is what tweeter did Nelson pass out with the Bofu's? And what was his recommended cross-over between them?
Thanks! -Tom-
What I really want to know is what tweeter did Nelson pass out with the Bofu's? And what was his recommended cross-over between them?
Thanks! -Tom-
Well, Pass has stated that he bought a couple hundred of these drivers because they are quite a value. In a BIB, your living room may resemble part of Stone Henge but the sound must be even more impressive.
Pass The Bofu Building a transmission line cabinet for the Pioneer 8-inch full range driver. Article By Jeff PothWhere are the Pass Bofu TL plans posted? I know that I have seen them, but now I can't find them.
What I really want to know is what tweeter did Nelson pass out with the Bofu's? And what was his recommended cross-over between them?
Thanks! -Tom-
follow the link to the drawing
- Status
- Not open for further replies.