Hello!
Maybe this topic have been up before but i couldent find any when searched.
Should the mains earth and amp starground be connected to one point on the chassis or should they be separated and connected to two different places on the chassis ?😕
Maybe this topic have been up before but i couldent find any when searched.
Should the mains earth and amp starground be connected to one point on the chassis or should they be separated and connected to two different places on the chassis ?😕
That thing uses a external ps and my poweramp is not a gainclone. Nevermind i´ll connect all ps grounds including mains gnd to one point on the chassis, and tie up all signal grounds to a starground and run a thin wire to the ps ground star.
I gonna have separate stargrounds for power and signal but only one connection to the chassis, the power gnd, and a wire from the signal gnd to the power gnd.
So nevermind this thread, i must have had a brainfart when posting it
So nevermind this thread, i must have had a brainfart when posting it
URL is death.
webarchive provide this:
Gainclone circuit diagrams.
Building a Gainclone chip amp
who know the new URL?
- Status
- Not open for further replies.