I have a spare LCD panel that I'd like to test out, but I have no power supply. It's a 3M 6100, with a 7-pin DIN socket for the power (not the more common 5-pin DIN).
Anyone have any idea as to the pinout? The only info I have states a universal-type, which could be interpreted to mean the +/- 12V/5V which is used in about 50% of devices using a 7-pin DIN. However, I've fried my share of electronics by trying to mix-n-match power supplies, and I'm confident that this panel worked before the PS was lost...
Any ideas?
Anyone have any idea as to the pinout? The only info I have states a universal-type, which could be interpreted to mean the +/- 12V/5V which is used in about 50% of devices using a 7-pin DIN. However, I've fried my share of electronics by trying to mix-n-match power supplies, and I'm confident that this panel worked before the PS was lost...
Any ideas?
RE 3M 6100 PANEL POWER SUPPLY
GADAY MATE
I HAVE THE SAME PROBLEM.DID YOU GET ANY MORE INFORMATION
FROM ANY BODY?IF YOU DID ANY CHANCE OF SENDING TO ME.
REGARDS
HANAN
GADAY MATE
I HAVE THE SAME PROBLEM.DID YOU GET ANY MORE INFORMATION
FROM ANY BODY?IF YOU DID ANY CHANCE OF SENDING TO ME.
REGARDS
HANAN
- Status
- Not open for further replies.