post not shown

Status
Not open for further replies.
I got an e-mail notification for a reply to my thread "Dummy load for tube amp" , but I can't see it in the forum.
Jim the Oldbie has just replied to a thread you have subscribed to entitled - Dummy load for tube amp - in the Tubes / Valves forum of diyAudio.

This thread is located at:
http://www.diyaudio.com/forums/tubes-valves/293481-dummy-load-tube-amp-new-post.html

Here is the message that has just been posted:
***************
Isn't there a potential for damage from output transformer inductive kickback when switching tube amps around like this? You might need to make sure to use a shorting (make-before-break) switch here, or something. Hopefully one of the tube gurus will step in here and school us on this.

-- Jim
 
Status
Not open for further replies.