On the Aleph 3 and 4 the base of ZTX450/MPSA18 is connected to the R26/R113 (bias setting resistor) and C6/C103 220µF caps....But according to the Aleph 5 schemaic it isnt?...(also Mark finnis layout is made out that way).....
Is this wrong or am i just to tired (its 3AM here..)
/micke
Is this wrong or am i just to tired (its 3AM here..)
/micke
micke,
Call it an ambiguity.
Using the Aleph 5 nomenclature:
There is a node that includes the base of the MPSA18/ZTX450, R19, R20, and C10.
Grey
Call it an ambiguity.
Using the Aleph 5 nomenclature:
There is a node that includes the base of the MPSA18/ZTX450, R19, R20, and C10.
Grey
One of the Alephs and I do believe it is the Aleph 5 operates very differently to the other Alephs. I asked Papa about this and he said it was intentionally made to operate differently, I think for better bass control from memory.
If you post the circuits it would be far easier for people to comment specifically though.
If you post the circuits it would be far easier for people to comment specifically though.
Holy thread resurrection, Batman!
Most likely you kit the last page arrow instead of the next page one. 🙂
Most likely you kit the last page arrow instead of the next page one. 🙂
