Hello,
I am new to speaker building and wonder if anyone can help me figure out what the crossover should be for a two way system. I have for the tweeters a polydax HD88D19MK, 8 ohms. (Can't find out anything in terms of frequency response, etc., would greatly appreciate any information here 🙂 )
For the midbass I have an Audax HR170F0, 6.5 inch driver with a fiberglass cone. Told that the frequency response on this is out to 5,000.
I have a crossover from a Jamo speaker, made by Elytone. I was told that this has a crossover point of 3.5.
Do you think that these parts could possibly result in a decent loudspeaker? Thanks in advance for your help. Take care.
Roman
I am new to speaker building and wonder if anyone can help me figure out what the crossover should be for a two way system. I have for the tweeters a polydax HD88D19MK, 8 ohms. (Can't find out anything in terms of frequency response, etc., would greatly appreciate any information here 🙂 )
For the midbass I have an Audax HR170F0, 6.5 inch driver with a fiberglass cone. Told that the frequency response on this is out to 5,000.
I have a crossover from a Jamo speaker, made by Elytone. I was told that this has a crossover point of 3.5.
Do you think that these parts could possibly result in a decent loudspeaker? Thanks in advance for your help. Take care.
Roman