multiple 6x9 speakers at one channel

[tobler]

hii all
i have sony amplifier xm-504z 4 channel amp. that is stable at 2 ohm
and i have 4 speaker pioneer TS-A6971e 6x9 350w 4 ohm impedance
so, i'm planing to hook up 2 speaker at one channel
each speaker 4 ohm impedance when hook it in parallel it'll be 2 ohm total impedance
i was asking that the speaker support 2 ohm ?????
or it will blow up?
plz help me

 

[tobler]

need help

plzz someone help meeee

 

[Netlist]

Tobler,
It's not the speakers who care about the impedance but the amplifier. There is no way you can damage the speakers by wiring them into 2ohm if indeed the amp can take that load.

/Hugo 🙂

 

[nicku1302]

if your amp does indeed say it can take a 2ohm load then yes you can run 2 6x9's in parralell on 1 channel of your amp without any problems.