This amp uses MTP50N06 as the outputs .
Can I use IRF540 or IRFZ44’s as outputs for testing before I order new parts to see if anything else in the channel is bad ?
Can I use IRF540 or IRFZ44’s as outputs for testing before I order new parts to see if anything else in the channel is bad ?
I used IRF540 for the outputs and set the bias in all 4 channels :
Amp has been playing for 2 hrs with no problems
Amp has been playing for 2 hrs with no problems
The 540s were just for testing right? I wouldn't use them since they're rated so much lower than the originals unless this is your personal amp that you don't intend to sell.
Outputs on that amp should be IRF540. I've never seen 50N06's in the output of any of those amps.