• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Mezmerize DCB1 without Salas Shunt Reg

Status
Not open for further replies.
The pcb is almost complete, you will need a pot, a selector switch and a +/-9V PSU.
The matched quad 2sk170bl-s are from Spencer.
Relays: EA2-12NJ NEC | Mouser
Resistors: Dale RN55D / RN60D
The Mezmerize was tested with the Salas shunt reg.
The traces are not cutted just scratched.
The price : 25 EUR + shipping.
PayPal preferred.
 

Attachments

  • IMG_1821.JPG
    IMG_1821.JPG
    774.9 KB · Views: 272
  • IMG_1822.JPG
    IMG_1822.JPG
    401.5 KB · Views: 250
  • IMG_1825.JPG
    IMG_1825.JPG
    446.1 KB · Views: 236
  • IMG_1827.JPG
    IMG_1827.JPG
    562.7 KB · Views: 330
The extra +V/0 does not need be separately produced, it can come off the pins of the positive side raw dc filter capacitor. Which is always higher than the regulated output. A 12-0-12VAC 30VA transformer for LM317 & LM337 is the easiest scheme.
 
Status
Not open for further replies.