hi, I just bought an old Maggie console with a 8601-20 amp in it for 45 bucks. which pins do I jump to get it to power up? was working in console already when I went to look at it. I know it needs some work but I wanna power it up.
also, if anyone wants the rest of it I am in brookpark ohio. you will have to come get it. PM me.
Last edited:
![securedownload[1].jpg](/community/data/attachments/375/375184-710256ae4cf683c049beb0504c24ab88.jpg?hash=cQJWrkz2g8)
the multi pin seems to go through what I believe is a multiplexer, then to the tuner/pre, then to the selector switch. :/ I really don't want to take it apart anymore than I did.
Looks like this diagram is what you'd need.
An externally hosted image should be here but it was not working when we last tested it.
thanks very much! I found this one with slight mods, do I just remove these tone parts or do they need to be replaced with a jumper or something?
By the way, this amp already sounds pretty good with very inefficient Martin Logan Aerius I's.
By the way, this amp already sounds pretty good with very inefficient Martin Logan Aerius I's.
An externally hosted image should be here but it was not working when we last tested it.
Remove those caps (and jumper out the 33K resistors) for a flat frequency response. They're equalization to match the speaker and passive tone controls. They're in the amp because that's the only place with any gain.
- Status
- Not open for further replies.