Hello, making my first chip amp that I am actually spending money on 😛.
Well, as a newbie, of course I have some issues.
Disclaimer, I do apologize if this has been covered. I didn't find anything by google. Probably because my word choice is poor.
So I have a normal out board psu, +18 -18 and earth. 25 amp bridge rectifier and 0.12 farad soothing caps (yes farad not uf, I got them for free at work).
The issue I am having is that my amp is "popping" when on and the sound is distorted. The positive rail goes to +28v and the negative rail drops in voltage to about -8v.
When in open circuit the voltage is steady at +18 and -18 respectively.
LM1875 is the exact same as what TI calls for in its normal dual power supply circuit.
So thats where I am at,
Look forward to any and all replies
Thank you!
Well, as a newbie, of course I have some issues.
Disclaimer, I do apologize if this has been covered. I didn't find anything by google. Probably because my word choice is poor.
So I have a normal out board psu, +18 -18 and earth. 25 amp bridge rectifier and 0.12 farad soothing caps (yes farad not uf, I got them for free at work).
The issue I am having is that my amp is "popping" when on and the sound is distorted. The positive rail goes to +28v and the negative rail drops in voltage to about -8v.
When in open circuit the voltage is steady at +18 and -18 respectively.
LM1875 is the exact same as what TI calls for in its normal dual power supply circuit.
So thats where I am at,
Look forward to any and all replies
Thank you!
Yep for the positive rail its on the + side and the - is on the other side for the other cap. Its a screw down cap with + and - marked on it.
So for the cap on the positive rail it is paralleled in and has the negative grounded. So conversely the negative rail has the negative side paralleled, and the positive side to ground. Like all other psu's I have seen.
Do you have center tap of the transformer connected to the ground? It seems to me that your ground is floating.
It is the reason of strange behavior. You need to fix that ground somehow. You can borrow circuit used in newer Quad306/520/606....family. Other way is to use transformer with center tap I'm afraid.
Cheers
Cheers
Ah...one more thing. Just for test. You can use 2 let say 180E/5W resistors (value is not critical though), and connect one from + to gnd and the other from - to gnd. It will probably work good enough to see if amp is working or you have some other problems.
Cheers
Cheers
- Status
- Not open for further replies.