laminating Hedlund Horns

[KMMM]

Hi

Does any one know if there's plans to be found regarding laminating Hedlun Horns?
Been searching the net, but hav not found any.

appriciat any tips

Best regards 🙂

KŒre

 

[Scottmoose]

http://www.hornet.hr/Hornet.asp?sPage=Veliki

 

[KMMM]

Thanks

I'm not sure about this link as it leads to a totally different speaker then the Hedlund Horns?
Yes, I have noticed that these people sell the Hedlund Horns, but I was kind of thinking about making them my self... of laminated veneer, - Yes, just like the Hornet version.

Hedlund's plans show how to build them from MDF, I could probably find all the measurements to make the laminating form like this:

http://sparkgap.homestead.com/Hedlund.html

But if the measurements are available it would be a lot easier.

Does any one know if there are drawings/plans available some where?

Best regards
KŒre

 

[Scottmoose]

The link should have read http://www.hornet.hr/Hornet.asp?sPage=Hedlund

However, if you selected the 'Hedlund' tab from the earlier link you would have got to it.

 

[germpod]

Those are fine looking horns. Bending thin pieces of wood would be time consuming, but it sure looks good.

 

[KMMM]

Hi

Yes, They look nice. And the bending of the veneer is something I have not tried yet.
So it's got to be tried once! 🙂

I think that making the forms will be the most time consuming.
But first thing first; to find OK measurements to make the laminating forms....

KŒre

 

[JeremyB]

It might be easier to bend the substrate first. either using kerfing, or soaking, or mutiple peices of 1/8 material, and then apply the veneer. Just a thought.

 

[KMMM]

Hi

Thanks.

A friend of mine is a furniture/cabinet maker. I noticed he had some serrated MDF.
really easy to bend. Can be bougt in different dimentions.
My plan was to make a sandwitch construction with the MDF between the veneered layers.
I think this would make the it less ressonant?

KŒre

 

[Audio_idiot]

Hi,
I'd build a pair of hedlund, using 3mm plywood laminate.
Damping is never a problem, just keep add layers of ply until you are happy with the good old trusty "knocking test". mine is 8 layers.

 

[KMMM]

Hi

Where did you take the measurements from to make a laminating jig?
Did you calculate them your self?

best regards
KŒre

 

[Audio_idiot]

I draw out the published drawings and round off the edges with a curve ruler.
BTW, As long as you can get true enough with your work, you don't have to be precision with the dimention, +/- 3~5mm is perfectly fine when it comes to woodworking😉

Merry x'mas