Im in the mists of repairing this kx series amplifier. The power supply was burnt badly.
going with irf3205's i used 47R gate resistors, is this ok? it had 100R.
Also C21 Melted and burned up, a safty capacitor 222k630v. Can you tell me the part # or where to find this? that is .022uF 630v correct?
what are the ps drivers? I'm having a issue with the loosing the drive signal when a load cap is installed.
i see three of them and the markings are asg/alg maybe kta1504l/ktc3874l so i was going to use 1gm/2gm
going with irf3205's i used 47R gate resistors, is this ok? it had 100R.
Also C21 Melted and burned up, a safty capacitor 222k630v. Can you tell me the part # or where to find this? that is .022uF 630v correct?
what are the ps drivers? I'm having a issue with the loosing the drive signal when a load cap is installed.
i see three of them and the markings are asg/alg maybe kta1504l/ktc3874l so i was going to use 1gm/2gm
Attachments
Last edited:
The amp originally used IRF3205's with 100 ohm gate resistors. Q10 and Q15 are the Gate Drivers A1504GR's. C21 is a .0022uF or 2.2nF 630v.Box Mylar
Check R500-100 ohm 2watt