WTB K & K Balanced Shunt Switched Attenuator

[nautibuoy]

A bit of a long shot but does anyone have K&K Balanced Shunt Switched Attenuator surplus to requirements, or the K&K kit documentation/schematic that I could utilise to build my own.

I would prefer to have purchased from K&K direct but it seems Kevin has retired and is no longer operating sales on his site. I have messaged his contact mail address from previous purchases but have not had a response.

http://www.kandkaudio.com/line-stage/

 

[StevenCrook]

Curious, why this one? Had a look at the K&K site and it's a neat design though.

I do remember this from EUVL as far as I'm aware no gerbers though. He did something similar for an ALPS pot, but I can't find that at all ATM.

 

[nautibuoy]

Hi Steven. I have used the K&K one before and it was very good,and cost effective too. I would like to explore using it in a project I have in mind.

 

[abanico]

I have the exel from K&K audio to calculate by yourself the values of the resistors .

 

[Greg Stewart]

Ray, sorry I missed this. Sending an email...

Greg in Mississippi

 

[Greg Stewart]

Also I had missed that Kevin Carter died earlier this month...

https://www.diyaudio.com/community/threads/rip-kevin-carter.409387/

Saddened.

RIP Kevin!

Greg in Mississippi