This goes along with my "SSE trouble" post. Another post from 2019 titled “Tubelab SSE blown C12 and R17 should I replace board” asked if their board was too burnt to reuse after R17 fried. It showed minor scuffing to the board. George mentioned if it’s brown it should be ok, but black causes issues with higher voltages. Well, how about this PC board burn spot, picture attached. Is the board toast? It’s under R17 where only about 50V runs. Do I need a new board?
-
Disclaimer: This Vendor's Forum is a paid-for commercial area. Unlike the rest of diyAudio, the Vendor has complete control of what may or may not be posted in this forum. If you wish to discuss technical matters outside the bounds of what is permitted by the Vendor, please use the non-commercial areas of diyAudio to do so.
