Hi everybody.
I'm still working on my design here. Working in Vituixcad 2 running simulations.
Here is a 2 woofer 2 mid range bass reflex cabinet design.
I have posted the impedance and phase plots here, and would like some feedback.
Minimum impedance is 3.24 ohms at 153 Hz.
My questions are:
What would the nominal impedance of this cabinet be?
Are there any issues with phase?
My amp is a two ohm capable class D. Is this a safe load?
I'm still working on my design here. Working in Vituixcad 2 running simulations.
Here is a 2 woofer 2 mid range bass reflex cabinet design.
I have posted the impedance and phase plots here, and would like some feedback.
Minimum impedance is 3.24 ohms at 153 Hz.
My questions are:
What would the nominal impedance of this cabinet be?
Are there any issues with phase?
My amp is a two ohm capable class D. Is this a safe load?
Attachments
Hmm
This amp is a Mesa d800+. It's rated by the manufacturer at 400 watts into 8 ohms, 800 watts into 4 or 2 ohms.
At 10% distortion mind you. So more likely 300/600 reasonably clean.
B&O Icepower 700 S1 module equipped if I'm not mistaken.
I can say however that it will generate a ton of spl with a good cab.
But that's a topic for another thread.
This amp is a Mesa d800+. It's rated by the manufacturer at 400 watts into 8 ohms, 800 watts into 4 or 2 ohms.
At 10% distortion mind you. So more likely 300/600 reasonably clean.
B&O Icepower 700 S1 module equipped if I'm not mistaken.
I can say however that it will generate a ton of spl with a good cab.
But that's a topic for another thread.
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.