I hope I'm posting in the correct forum. I have a old pair of HiVi M200's with a blown amplifier. The amp had a buzz, so I recapped the board. It worked fine for about 10 minutes and then the power supply burned up. So rather than repairing it, ive decided up upgrade the electronics to new. Does anyone have any recommendations or advice?
There doesn't seem to be anyone on the web who sells hivi parts. I was thinking that I'd replace the amp with a class d amp.
Thoughts?
There doesn't seem to be anyone on the web who sells hivi parts. I was thinking that I'd replace the amp with a class d amp.
Thoughts?
There are several US dealers, did you reach out to them?
HIVI Sales network-Sales network-HiVi
It's difficult to replace these built in modules as they are tailored to the drivers. I would reach out to hivi.us directly or a dealer first.
Best,
Erik
HIVI Sales network-Sales network-HiVi
It's difficult to replace these built in modules as they are tailored to the drivers. I would reach out to hivi.us directly or a dealer first.
Best,
Erik
Also, measure the impedance of the drivers too. It may be your real problem is a blown woofer. 🙂
Best,
Erik
Best,
Erik
- Status
- Not open for further replies.