I am new at speaker building. I purchased a couple of full range 4" drivers. I was wondering if there is a website that I could enter in my speaker specifications and get dimensions for different types of enclosures. Does anyone have any suggestions? Thanks for your help.
Don't know much about computers, but the software here runs on my G4 mac laptop.
www.ishtek.com/software_ts.html
Hope this is of some use.🙂
www.ishtek.com/software_ts.html
Hope this is of some use.🙂
You can download ported.xls here:
http://www.diysubwoofers.org/prt/
This works well for ported and sealed enclosures.
Joe
http://www.diysubwoofers.org/prt/
This works well for ported and sealed enclosures.
Joe
Martin's MathCad worksheets and a free version of MathCad:
www.quarter-wave.com There are ways of making them work with Macs.
Be afraid. Be very afraid.
Scott
P.S. They're actually dead easy to use -they just look a little daunting.
Best
Scott
www.quarter-wave.com There are ways of making them work with Macs.
Be afraid. Be very afraid.
Scott
P.S. They're actually dead easy to use -they just look a little daunting.
Best
Scott
Hey, scottmoose, your're in Anlaby eh?
I used to live near Hull until I came to live in ozz 6 months ago!
Small world innit?
🙂
I used to live near Hull until I came to live in ozz 6 months ago!
Small world innit?
🙂
bobhayes said:
That it is. I can't imagine why you sacrificed the bountiful joys of Hull for Australia though 😉
Whereabouts were you based before the big move?
Scott
- Status
- Not open for further replies.