I'm restoring big old speakers that have Goodmans Trebax (with crossover build in) and Wharfedalle Super. The original connections were made wrong as I had to run one speaker in reversed polarity. I need to do new wiring but there is nothing on the Goodmans that would indicate Positive / Negative or even crossover to speaker connection or main signal input.
I'm hoping someone might know, I can't find any info on the Net.
I'm hoping someone might know, I can't find any info on the Net.
Last edited:
I've figured it out so if someone needs to know this is how it goes.
Four connector screws on the back. Top left is crossover positive speaker out, right is negative.
Bottom left is main input positive, right negative.
The center of the big sticker is on the left side, the right side is where the sticker ends (both ends).
Four connector screws on the back. Top left is crossover positive speaker out, right is negative.
Bottom left is main input positive, right negative.
The center of the big sticker is on the left side, the right side is where the sticker ends (both ends).
It's this one
An externally hosted image should be here but it was not working when we last tested it.
Yes it's oval
An externally hosted image should be here but it was not working when we last tested it.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Loudspeakers
- Full Range
- Goodmans Trebax wiring