• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

FS: 12" Sub drivers, Marchand XM1 w/PS

Status
Not open for further replies.
Jump to Latest
nodiak

nodiak

Member
Joined 2004
#1
Meniscus SW1284 12" subwoofers. Very little use. $200 (new $300). Same as used in ACI subs. Commonly used in 3 ft3 sealed. Have a Greg Monfort designed mltl cab plan can share too.

Marchand XM1 crossovers, pair for stereo. PS10 power supply. Never used. $70 ($134 new). These units bought assembled by Marchand. Need chassis and wired for operation. Have Burr Brown op amp upgrade. 70 hz resistor modules now, other frequency resistors modules are $6 each from Marchand.

Potentiometers, knobs and rca jacks for above. Never used $25 ($39 new).

Moved from large room where I was going to make stereo subs with above. Bought a small sub for my new small room.

$265 takes everything ($295 seperate prices).

Thanks, Don
nodiak@sbcglobal.net
 
Status
Not open for further replies.
Top Bottom