Picked up a ex PSA driver from there original XS15 XV15 series. I cannot find the specs for it and was wondering whether to just copy the sealed design or try and make a ported version. Any advice would be very helpful.
If you know anyone with Woofer Tester III, they could measure it for you. Or, contact PSA to get the specs. Some companies won't share specs. In that case just copy the box design.
That is a massive sub.
That is a massive sub.
A second thought. There may be EQ built into the amp, so measuring would be the best way to find out exactly what you have.
Thanks Djn, I suspect there might be some low end boost to get the numbers they advertised in the XS15 & XV15.
Anyone in Melbourne or Geelong area with a woofer Tester III.
It is a big heavy sub. Its from FI car audio and looks well built.
Deep HZ are selling them for $200 delivered which seems like a good deal downunder.
Anyone in Melbourne or Geelong area with a woofer Tester III.
It is a big heavy sub. Its from FI car audio and looks well built.
Deep HZ are selling them for $200 delivered which seems like a good deal downunder.
Got a chance of picking up a Peavey CS4000 for this project.
Can I just use one channel until I get another driver?
Can I just use one channel until I get another driver?
Finished Sub
Finally finished this Sub about 6 mths ago. Very happy with the result. Picked up a seconhand O Audio 500w plate amp which works well at a 25 hz tune. The chess board pieces are made of Blackwood & Satin Box with a Tassie Myrtle surround. The Box is spray can painted white with a clear shellac finish.
Finally finished this Sub about 6 mths ago. Very happy with the result. Picked up a seconhand O Audio 500w plate amp which works well at a 25 hz tune. The chess board pieces are made of Blackwood & Satin Box with a Tassie Myrtle surround. The Box is spray can painted white with a clear shellac finish.
Attachments
Last edited:
- Status
- Not open for further replies.