This amp uses 10 ohm gate resistors .
I’m gonna use IRF3205’s as the fets .
I know I can leave the gate resistors alone but a few are out of tolerance .
Can I use 47 ohm gate resistors ?
I’m gonna use IRF3205’s as the fets .
I know I can leave the gate resistors alone but a few are out of tolerance .
Can I use 47 ohm gate resistors ?
The 47s should be OK. If the PS FETs run hot at idle at full duty cycle (may have to reduce 12v supply voltage), you may need to adjust the deadtime.
Why do you want to switch to 47 ohm?
Why do you want to switch to 47 ohm?
I just received the parts today and forgot to order the gate resistors and 47 ohm is all I have on hand right now .
But I’ll double check and see if I have any 10 ohm
But I’ll double check and see if I have any 10 ohm