dual heat sinks

[wdecho]

I am in the process of building the SE amp and the part # for the dual heat sinks is obsolete. Will this be satisfactory to fit on the board?

Electronic Components and Parts Search | DigiKey Electronics

 

[brianco]

Go to the DIYaudio store for your heatsinks etc. They now offer all 40mm sizes! Even predrilled & tapped if required.

 

[wdecho]

Go to the DIYaudio store for your heatsinks etc. They now offer all 40mm sizes! Even predrilled & tapped if required.

These are the little dual heatsinks for the tubelab SE tube board not the ones for the Firstwatt builds. Thanks for responding though.

 

[wdecho]

I ordered my SE board Tuesday from George and today I got it in the mail. Fast service. Since I now have the board in hand I can take some measurements and see if the heatsinks at digikey will work.

 

[tomchr]

I bet you can find a couple of U-shaped heat sinks that'll work. If not, a strip of aluminum bent into a U shape mounted to each device will provide a surprising amount of cooling.

Tom

 

[wdecho]

Yes Digikey had what I needed. When I first posted I did not have board in hand. After receiving the board all it took was some simple measurements to find my answer.