I'm investigating the market for CAN drivers ... but.... for the old trailer CAN according the ISO 11992-1 (24 volt signal levels, hardware) and 11992-3 (the protocol). So far I have only found one old "not recommended for new design" chip from Atmel called B10011S.
Anybody whos knows anything about the subject?
(There are lot's of drivers for the 5 V CAN bus)
Anybody whos knows anything about the subject?
(There are lot's of drivers for the 5 V CAN bus)
Last edited:
Some digging and it turns up that ON Semi manufactures a chip similar to B10011S but it's not sold in the open market... yet.
- Status
- Not open for further replies.