ALL INVITED for sharing their knowledge for making really GOOD drivers, and full information can be shared for improving driver constuction.
As myself i have made a couple of not so good drivers for Pro 12", 15", 18" and still eager to make more driver & keep on improving.
I personally feel, most of the engineers should support for this thread, to let DIY know the common mistakes they do, while making drivers.
As myself i have made a couple of not so good drivers for Pro 12", 15", 18" and still eager to make more driver & keep on improving.
I personally feel, most of the engineers should support for this thread, to let DIY know the common mistakes they do, while making drivers.
Sonu:
that is because there have been at least two different threads on the same subject, and people have presumed you have checked them out first.
Here is one, by Ultima Thule:
http://www.diyaudio.com/forums/showthread.php?threadid=55484
Vikash had one some time ago-I'll try to dig it up.
that is because there have been at least two different threads on the same subject, and people have presumed you have checked them out first.
Here is one, by Ultima Thule:
http://www.diyaudio.com/forums/showthread.php?threadid=55484
Vikash had one some time ago-I'll try to dig it up.
And here is one from Vikash.
http://www.diyaudio.com/forums/showthread.php?threadid=17936&highlight=
Check these out and see what you can get from them, then ask specific questions about how to proceed on your own.
By the way, will you be ordering the machined parts-the yoke, etc-or will you be machining them yourself?
http://www.diyaudio.com/forums/showthread.php?threadid=17936&highlight=
Check these out and see what you can get from them, then ask specific questions about how to proceed on your own.
By the way, will you be ordering the machined parts-the yoke, etc-or will you be machining them yourself?
- Status
- Not open for further replies.