can anyone tell me why this is happening:
i thought a diode was bad because when i measured it in the circuit, one reading was 700 ohms (good) and 1400 ohms the other way (bad) shouldn't it be infinity?
so i replaced it with another that i measured 700 ohms one way and infinity the other, and when i read it in the circuit again, i got 700 and 1400 the other way????
the other channel same component diode reads 700 and infinity ( again, readings with component in the circuit.
something is going on, but i'm not sure what.
any ideas?
thanks,
scott
i thought a diode was bad because when i measured it in the circuit, one reading was 700 ohms (good) and 1400 ohms the other way (bad) shouldn't it be infinity?
so i replaced it with another that i measured 700 ohms one way and infinity the other, and when i read it in the circuit again, i got 700 and 1400 the other way????
the other channel same component diode reads 700 and infinity ( again, readings with component in the circuit.
something is going on, but i'm not sure what.
any ideas?
thanks,
scott
- Status
- Not open for further replies.