Where would a pot be placed in this circuit to control the gain. I have read in various places that a 100k pot can be used on the output side. Would it just replace the 100k resistor or be added in addition to the existing 100k resistor on the output? Or somewhere else?
Attachments
That’s a long debate explored elsewhere on this forum. It can go on the input or the output for different objectives. I’m specifically asking for help adding it to the output.
Here is a link to the recommendation from Decware: https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1279035132
The before or after subject was exhausted here: https://www.diyaudio.com/community/threads/input-or-output-pre-amp-volume-control.398327/
What is the best way to control the output voltage of the circuit I attached at the beginning of this thread?
The before or after subject was exhausted here: https://www.diyaudio.com/community/threads/input-or-output-pre-amp-volume-control.398327/
What is the best way to control the output voltage of the circuit I attached at the beginning of this thread?