I was just on the TI site and happened to see an add for this device.....
http://www.ti-estore.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=EZ430-RF2500
I have zero programming experience, but just out of curiosity, could it be programmed to send and output a SPDIF signal?
http://www.ti-estore.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=EZ430-RF2500
I have zero programming experience, but just out of curiosity, could it be programmed to send and output a SPDIF signal?
The wireless transceiver in this module (CC2500) is only good for 500kbps. 44.1KHz x 16bit x 2 = 1.411mbps. The other problem is that S/PDIF carries clock information as well, and the wireless transmission is probably buffered and doesn't offer a way to propagate the clock across the link.
So, unfortunately not possible. At the very least it'd be a lot of work - if it were fast enough you could probably get it to work by using large buffers and sending the clock rate in a side channel and regenerating it at the remote end - but it doesn't sound feasible.
Another application for peufeu's ethernet sound interface - slap it behind a wireless bridge and you've got wireless audio...
So, unfortunately not possible. At the very least it'd be a lot of work - if it were fast enough you could probably get it to work by using large buffers and sending the clock rate in a side channel and regenerating it at the remote end - but it doesn't sound feasible.
Another application for peufeu's ethernet sound interface - slap it behind a wireless bridge and you've got wireless audio...
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.