D dobias Member Joined 2007 2009-10-16 10:39 pm #1 2009-10-16 10:39 pm #1 Are there any Ashland hysteresis motors available? directdriver Member Joined 2005 2009-10-16 11:24 pm #2 2009-10-16 11:24 pm #2 You can take one out of a Rek-o-kut or McCurdy idler drive turntable. D dobias Member Joined 2007 2009-10-20 2:55 am #3 2009-10-20 2:55 am #3 Ashland motor The Ashland motor used on the idler drive B-12H had a 0.3125 inch shaft. That would not work with a belt drive N-33 or K-33. They need a shaft size (pulley) of 0.21875 for 33.33 rpm. Status Not open for further replies. Share: Facebook X (Twitter) LinkedIn Reddit Pinterest Tumblr WhatsApp Email Link
directdriver Member Joined 2005 2009-10-16 11:24 pm #2 2009-10-16 11:24 pm #2 You can take one out of a Rek-o-kut or McCurdy idler drive turntable. D dobias Member Joined 2007 2009-10-20 2:55 am #3 2009-10-20 2:55 am #3 Ashland motor The Ashland motor used on the idler drive B-12H had a 0.3125 inch shaft. That would not work with a belt drive N-33 or K-33. They need a shaft size (pulley) of 0.21875 for 33.33 rpm. Status Not open for further replies.
D dobias Member Joined 2007 2009-10-20 2:55 am #3 2009-10-20 2:55 am #3 Ashland motor The Ashland motor used on the idler drive B-12H had a 0.3125 inch shaft. That would not work with a belt drive N-33 or K-33. They need a shaft size (pulley) of 0.21875 for 33.33 rpm.
Ashland motor The Ashland motor used on the idler drive B-12H had a 0.3125 inch shaft. That would not work with a belt drive N-33 or K-33. They need a shaft size (pulley) of 0.21875 for 33.33 rpm.
