Hi, I m complete noob regarding this. But I don't think it would be hard to make a switchbox. I need to be able to switch 1 input (L+R) to 3 outputs (also L+R).
I guess the only problem is how to wire the actual switch. Can I use something like this http://www.mgelectronic.rs/components/prko26-sema.jpg
I guess these rotary switches are easiest solution.
Any help from you guys would be appreciated.
Milan.
I guess the only problem is how to wire the actual switch. Can I use something like this http://www.mgelectronic.rs/components/prko26-sema.jpg
I guess these rotary switches are easiest solution.
Any help from you guys would be appreciated.
Milan.
A/B/C switch
I can't see the draw.
Just remember there is a common for the three options just change the (+) pole
I can't see the draw.
Just remember there is a common for the three options just change the (+) pole
I can't see the draw .
Just remember for the three options there is a common.
Just need conect the (+) pole to the selector
Just remember for the three options there is a common.
Just need conect the (+) pole to the selector
- Status
- Not open for further replies.