I have a heavily modified Lite 60 (Monarchy NM22 without the preamp) and I was wondering what is an acceptable load (Preamp) to allow the 6922 output tubes not to be overloaded.
I have a NAD S-300 (built by Gryphon in Denmark) that has a passive preamp (no active components prior to the potentiometer) and a 10K potentiometer. I believe this load is too much for the Lite 60 6922 tube based output.
I sense a little distortion in regards to overload....
I wanted to replace the 10K Blue Velvet Alps with a 50-100K potentiometer to lighten the load for the 6922's.
What are the consequences in regards to changing the pot from 10K to 100K?
Any help would be appreciated.
Thanks,
I have a NAD S-300 (built by Gryphon in Denmark) that has a passive preamp (no active components prior to the potentiometer) and a 10K potentiometer. I believe this load is too much for the Lite 60 6922 tube based output.
I sense a little distortion in regards to overload....
I wanted to replace the 10K Blue Velvet Alps with a 50-100K potentiometer to lighten the load for the 6922's.
What are the consequences in regards to changing the pot from 10K to 100K?
Any help would be appreciated.
Thanks,
- Status
- Not open for further replies.