• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

50K volume pot split shaft needed

Status
Not open for further replies.
Need a new volume pot for an HK 330A. It's got a split knurled shaft and a loudness tap, audio taper. Will use anything 50K with the right shaft... Hard to find, linear or otherwise. The spline section's about 3/8" long and the shaft length total is probably ~5/8". Any ideas appreciated...
 
Status
Not open for further replies.