I'm using Panasonic TUP caps on a board I made. Terminal 3 & 4 do not have any connection to either plus or minus, but the printing on the cap say do not connect. It was easiest to lay out the board whil making connections to these pins. Will this cause any problems?
Hi.
I was with the same doubt. Then I looked at google with the cast snap on capacitors, and I found this data-sheet.
http://www.cde.com/catalogs/380-382.pdf
inside, you can see that this capacitor have extra terminals for a better assembly montage/support.
I rope this information helps you also.
I was with the same doubt. Then I looked at google with the cast snap on capacitors, and I found this data-sheet.
http://www.cde.com/catalogs/380-382.pdf
inside, you can see that this capacitor have extra terminals for a better assembly montage/support.
I rope this information helps you also.
- Status
- Not open for further replies.