DIY CDPRO2 Player with Rubidium clock

[csw]

had made a CDPRO2 with Rubidium clock.

Use this Rubidium clock module



This module can be set from 2MHz to 18MHz , each step is 1Hz .

The spec of FE-5680A is as follow



This is my flow diagram.



1.

8.4672MHz Rubidium clock system






BNC clock output




2.

Rubidium clock system turn on (heat up until temperature = 50C (about 5 minutes) ) power consumption =38W


when temperature = 50C /power consumption =16W


Stable temperature is about 50C


continua................

[SY]

Since this is an advertisement, I have moved it to Vendor's Bazaar. Please use this thread only for any future ads.

[Guido Tent]

Originally Posted by csw

had made a CDPRO2 with Rubidium clock.

what's the jitter specification ?

best

[jean-paul]

Hi Guido, I have a rubidium clock too. If you like you can measure it (providing you have the right equipment to measure it). Should be better than oscillator modules given the purpose they were intended for.

[Guido Tent]

Originally Posted by jean-paul

Hi Guido, I have a rubidium clock too. If you like you can measure it (providing you have the right equipment to measure it). Should be better than oscillator modules given the purpose they were intended for.

Hi Jean-Paul,

Thanks, good to hear from you. I know how most of them measure. In addition the synthesizer in the backend adds jitter.

better is relative; If you need long term stability, they are OK. For audio they are a dead end.

best