Buffalo I and Legato 3 are compatible correct?

sbelyo · 22nd December 2011, 08:58 PM

I've finally collected all the parts and pieces to complete my buffalo DAC.

I have a Buffalo I and I am 99 percent sure it works with the Legato 3 that I have. I just wanted to doublecheck. I know that the latest reviosion of the Buffalo I was done to accomodate the stacking on top of the output mudules if I'm not mistaken.

Brian, or Russ can you comment?

Thanks
Steve

BrianDonegan · 23rd December 2011, 01:14 PM

Yes, the Legato will work perfectly with the Buffalo I.

sbelyo · 23rd December 2011, 01:51 PM

Let the work begin... Will be laying out the front and back panels during vacation.

Single ended will be fed to an elma 2P6T switch. Only three segments will be used. Two will have no volume control and sent straight to to my bottlehead carck and dynalo. The third segment will be volume controlled by an alps blue velvet 50K for my dynahi and other amps that have no volume control.

The balanced output will feed a balanced M³ once built

22nd December 2011, 08:58 PM	#1
sbelyo diyAudio Member Join Date: May 2004 Location: East Coast	Buffalo I and Legato 3 are compatible correct? I've finally collected all the parts and pieces to complete my buffalo DAC. I have a Buffalo I and I am 99 percent sure it works with the Legato 3 that I have. I just wanted to doublecheck. I know that the latest reviosion of the Buffalo I was done to accomodate the stacking on top of the output mudules if I'm not mistaken. Brian, or Russ can you comment? Thanks Steve

23rd December 2011, 01:14 PM	#2
BrianDonegan diyAudio Member Join Date: Dec 2004 Location: Rock Ridge	Yes, the Legato will work perfectly with the Buffalo I. __________________ Twisted Pear Audio

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Buffalo DAC II For Sale Complete with Legato	smanz	Swap Meet	1	18th November 2011 09:15 PM
Implementing Dual I/V for Buffalo II/III - Legato/IVY + Tube I/V	pinnocchio	Digital Line Level	2	7th September 2011 07:27 PM
FS: Buffalo II DAC + Legato I/V + set of Placid PS + 2 Transformators	Thomas Giz	Swap Meet	4	29th March 2011 10:55 PM
Legato or IVY III outputs for Buffalo II?	natzev_i	Twisted Pear	272	21st March 2011 08:08 PM
FS: Buffalo II DAC + Placid Combo, Legato I/V Stage, 2x Placid BP Modules	damohpi	Swap Meet	4	23rd November 2010 08:51 AM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read

23rd December 2011, 01:51 PM	#3
sbelyo diyAudio Member Join Date: May 2004 Location: East Coast	Let the work begin... Will be laying out the front and back panels during vacation. Single ended will be fed to an elma 2P6T switch. Only three segments will be used. Two will have no volume control and sent straight to to my bottlehead carck and dynalo. The third segment will be volume controlled by an alps blue velvet 50K for my dynahi and other amps that have no volume control. The balanced output will feed a balanced M³ once built

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)