Tube Library Pspice error

[Imarobot]

I've been working on a class AB push-pull amp for a school project and have gotten to the point where my instructor wants me to run some pspice simulations of my design. I searched around for Tube models and found a number of resources to accomplish what I needed.

Rather than making my own models I found some already made library's at:
http://www.next-power.net/next-tube/libs.php3

They show up in Pspice, and have parts that I can place in my schematic, but when I run a simulation I keep getting the following error:

.lib "nom.lib"

*Analysis directives:
.OP
.PROBE V(*) I(*) W(*) D(*) NOISE(*)
.INC ".\crapola-SCHEMATIC1.net"



**** INCLUDING crapola-SCHEMATIC1.net ****
* source CRAPOLA
R_R1 N00137 N00107 1k
R_R2 N00166 0 1k
X_VL2 N00137 N00166 0 12AX7
V_V1 N00107 0 200Vdc

**** RESUMING crapola-schematic1-asd.sim.cir ****
.END

ERROR -- Subcircuit 12AX7 used by X_VL2 is undefined


I just used a couple of random resistors and a DC powersupply to generate the error message... those elements are not part of my design.

Any ideas on how I can resolve this?

I've tried to go into model editor and generate a usable library, but that didn't resolve the issue, and from what I can tell the model parameters that are used are comparable to other models from sites like duncan amps, or norman koren.

Thanks in advance for the help.

[pmillett]

PSpice can't find the 12AX7 model... it isn't loaded.

What tool are you using?