Rose RV23 preamp

waynzworld · 10th January 2007, 11:31 AM

Hello Everybody
I have a Rose RV23 preamp that I'm trying to find a circuit of, it has an open circuit mains transformer and I need some output voltages to rewind it .
Any help,infomation or knowledge of this product would be greatly appreciated.

daviddavis · 1st May 2012, 12:29 PM

I have repaired one just now for a fellow. The secondary output voltages from the tramsformer (I presume yours is external to the Rose like this one here?) ought to be (and I don't know, I'm going from how the thing looks inside the main amp case) 250v for the ECC82 valves and about 13v for the heaters, which are wired in series (that is, from valve pin 4 to pin 9, and only then to pin 5. There is also a voltage stabiliser chip and a NE555, which would require about 12-15 volts. But it must be 13 as the two series heater sections in the valves are 6.3v and 6.3v.

10th January 2007, 11:31 AM	#1
waynzworld diyAudio Member Join Date: Feb 2006 Location: TAIRUA	Rose RV23 preamp Hello Everybody I have a Rose RV23 preamp that I'm trying to find a circuit of, it has an open circuit mains transformer and I need some output voltages to rewind it . Any help,infomation or knowledge of this product would be greatly appreciated.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tube Preamp Popping on Source Input Change (?) / 6DJ8 Preamp On Chip Amps	MartyM	Tubes / Valves	3	16th October 2008 04:52 AM
twisted pear Preamp/other suggestions for Preamp kit	LukeDuke	Chip Amps	1	1st February 2008 09:57 PM
Electret mic preamp - will phono preamp work?	darthmullet	Analogue Source	6	12th October 2007 07:32 AM
wiring preamp outs on a preamp	bonsai171	Solid State	4	22nd March 2004 10:13 PM
red rose and korsun	john-china	Solid State	1	4th June 2002 09:01 AM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read

1st May 2012, 12:29 PM	#2
daviddavis diyAudio Member Join Date: Feb 2010	I have repaired one just now for a fellow. The secondary output voltages from the tramsformer (I presume yours is external to the Rose like this one here?) ought to be (and I don't know, I'm going from how the thing looks inside the main amp case) 250v for the ECC82 valves and about 13v for the heaters, which are wired in series (that is, from valve pin 4 to pin 9, and only then to pin 5. There is also a voltage stabiliser chip and a NE555, which would require about 12-15 volts. But it must be 13 as the two series heater sections in the valves are 6.3v and 6.3v.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)