Counterpoint Sa-3000 Circuit Diagram

NickBRN · 30th September 2006, 01:39 PM

I must find Counterpont's (SA-3000) circuit diagram !!!

There are some serious problems like no sound at all from Line outputs !

Any help please...???

anatech · 1st October 2006, 01:44 AM

Hi NickBRN,
You are not going to find them at no cost. The manual is a book for one. Then there is the alignment needed whenever you replace the tubes.

Buy the manual from Mr. Elliot (as much as I hate to say that), or have a good technician set it up.

To start, what equipment do you have. I may be able to help a little in troubleshooting.

-Chris

NickBRN · 2nd October 2006, 12:39 AM

Hi Chris,

Yes I think you 're right...
Probably I will buy it straight from mr Elliot.
I see no other choice...

I bought this unit from eBay and it came in a terrible situation...
No sound at all, even from tape outs...!!!

Basically I was planning to use it as a phono stage straight to
my CAT Ultimate, but...

So I gave it to my technician who is really good and
he fix the phonostage which is more important to me.
Now I can use it as a phono from tapeouts!

About the Line stage he asked me to find its diagram.
That's my story Chris.....

Thanks for your advice and your interest!

Nick

anatech · 2nd October 2006, 02:54 AM

Hi Nick,
Make sure the switch is in the operate position for one. It isn't a very difficult unit to troubleshoot really. Post some questions from your tech, we'll try to answer them.

-Chris

30th September 2006, 01:39 PM	#1
NickBRN diyAudio Member Join Date: Sep 2006	Counterpoint Sa-3000 Circuit Diagram I must find Counterpont's (SA-3000) circuit diagram !!! There are some serious problems like no sound at all from Line outputs ! Any help please...???

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Counterpoint SA-3000	Kenaudion	Tubes / Valves	0	19th August 2008 11:14 PM
Suitable diagram so I can use 4x Telsa RD 200B and 8x Tungsram RG 250/3000	Acoustech	Tubes / Valves	1	3rd November 2007 11:25 PM
SA 3000 Counterpoint	Petergo	Tubes / Valves	0	17th July 2007 03:07 PM
Counterpoint DA11.5 circuit needed	cyliew	Digital Source	0	19th April 2007 06:30 AM
Power supply Schematic Counterpoint SA -3000 Help!	Audiofanatic	Tubes / Valves	2	4th February 2003 02:47 PM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read

1st October 2006, 01:44 AM	#2
anatech diyAudio Moderator Join Date: Jun 2004 Location: Georgetown, On	Hi NickBRN, You are not going to find them at no cost. The manual is a book for one. Then there is the alignment needed whenever you replace the tubes. Buy the manual from Mr. Elliot (as much as I hate to say that), or have a good technician set it up. To start, what equipment do you have. I may be able to help a little in troubleshooting. -Chris

2nd October 2006, 12:39 AM	#3
NickBRN diyAudio Member Join Date: Sep 2006	Hi Chris, Yes I think you 're right... Probably I will buy it straight from mr Elliot. I see no other choice... I bought this unit from eBay and it came in a terrible situation... No sound at all, even from tape outs...!!! Basically I was planning to use it as a phono stage straight to my CAT Ultimate, but... So I gave it to my technician who is really good and he fix the phonostage which is more important to me. Now I can use it as a phono from tapeouts! About the Line stage he asked me to find its diagram. That's my story Chris..... Thanks for your advice and your interest! Nick

2nd October 2006, 02:54 AM	#4
anatech diyAudio Moderator Join Date: Jun 2004 Location: Georgetown, On	Hi Nick, Make sure the switch is in the operate position for one. It isn't a very difficult unit to troubleshoot really. Post some questions from your tech, we'll try to answer them. -Chris

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)