diyAudio (
-   Tubes / Valves (
-   -   6c19p Se? (

Ryssen 21st May 2006 07:42 PM

6c19p Se?
I have 10 pcs of 6C19P thought of using some for a SE amp,they could use a OPT off 3,5-4K ohm,right?And what about using another for the driver or is the aplification to low?Better use a E81L or E208F?
Any suggestions?:)

Rtop84 21st May 2006 08:15 PM

You can use 6c19p in SE, but output power will be low, about 1.5W.

Ryssen 21st May 2006 09:07 PM

And what about the driver and OPT kan I go as low as 2,5K?
Or as high as 4K?

Rtop84 21st May 2006 09:14 PM

2.5k OPT will be better than 4k,because 6c19p is low Rp tube(300-500Ohm). For driver- perhaps ECC88 or E180F in triode connection will be good.

Ryssen 21st May 2006 09:21 PM

What about using a 6C19P as the driver to?:xeye: :rolleyes:

astouffer 21st May 2006 10:49 PM

Not enough gain.

arnoldc 21st May 2006 11:28 PM

use a step up transformer on the input to bump up the gain.

Rtop84 22nd May 2006 06:34 AM

6c19p as driver 6c19p is bad idea, because mu=2,5, but 6c19p is good driver tube for big power tubes,which like get some current to drive.

Ryssen 22nd May 2006 08:28 PM

Ok,thanks for the answers,Im thinking maybee Paralell SE with this one,should the OPT be 1K then and it should withstand about 150-190mA,right?

Rtop84 22nd May 2006 08:38 PM

OPT for max 160-180mA DC current should be O.K.(60mA-80mA per one tube).

All times are GMT. The time now is 01:46 AM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 18.75%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Copyright ©1999-2018 diyAudio