Hey Yoss! Nice build. Say, what kind of output transformers are they?
My another project : ED8000 SE
Driver tube : EF86/E80F
Power tube : ED8000
Rectifier tube : Py88
My first tube amp. A 6LU8 Spud. The schematics and such are available in this post.
The chassis is made from 18 mm think walnut. It measures 290 x 290 x 95 mm. Top plate is 1.6 mm aluminum. Bottom plate (not shown) is 1.6 mm aluminum perf plate.
~Tom
Nice!
I like single tube amps!
look likes this one make a bit more power than mine
My first valve amplifier, a pair of 6EM7s used, rectifier is a 5Z4.
Layout's not great, but the sound is pretty good...
Bias is from a pair of rechargable batteries, one per side.
Layout's not great, but the sound is pretty good...
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
Bias is from a pair of rechargable batteries, one per side.
An externally hosted image should be here but it was not working when we last tested it.
Let me guess: 6H8/9C + 6C4C?
Hey Yoss! Nice build. Say, what kind of output transformers are they?
Hi h00hbt,
My OPT is custom made from my friend in Thailand. Primary impedance = 1.5K but I plan to change in to 2.5K soon.
Hello Yoss,
Very nice builds! What kind of chassis did you use?
Hi jim,
The chessis made from folded 3mm aluminum sheet and spray by hammered paint.
I also enclosed some photo of my chessis work.
Attachments
I choose to parallel some triode tube to get more power ..............
12B4a PSET ........
12B4a + 9002 + 6AX5gtB
I like your aluminum plate design.
I gave it a try too about a year ago..
Attachments
- Home
- Amplifiers
- Tubes / Valves
- Photo Gallery