DIY Club remote volume help?

Sherman · 15th September 2005, 01:03 PM

I just received a remote volume control kit with switchable inputs from DIY Club (MV-01). However there are no instructions or even a schematic for it.

Some of the connections are easy, even for me such as things labeled 12V, 5V or Gnd. I'm assuming the 'a b c' connector is for the IR receiver but which pin is which?

The input switching relay board has a 6 pin connector that looks the same as one on the volume control board so it would be a decent guess they get hooked together- but... pin 1 to pin 1 or reversed? It appears the inputs should be soldered to the through-hole pads but maybe they go the the 7 pin connector?

As you can see I'm confused! If anyone here has ever used one of these I'd appreciate any help!

dine1967 · 15th September 2005, 01:08 PM

You can contact them and they will send you the details of connections with a writeup. Let me know if you are unable to get it from them, and I will email you.
thanks,
Dinesh

Sherman · 15th September 2005, 05:03 PM

Quote:

Originally posted by dine1967
You can contact them and they will send you the details of connections with a writeup. Let me know if you are unable to get it from them, and I will email you.
thanks,
Dinesh

Thanks! I emailed them earlier this morning so I'll give Johnny a couple days then come back if I don't hear from them.

15th September 2005, 01:03 PM	#1
Sherman diyAudio Member Join Date: Feb 2004 Location: Chicago area	DIY Club remote volume help? I just received a remote volume control kit with switchable inputs from DIY Club (MV-01). However there are no instructions or even a schematic for it. Some of the connections are easy, even for me such as things labeled 12V, 5V or Gnd. I'm assuming the 'a b c' connector is for the IR receiver but which pin is which? The input switching relay board has a 6 pin connector that looks the same as one on the volume control board so it would be a decent guess they get hooked together- but... pin 1 to pin 1 or reversed? It appears the inputs should be soldered to the through-hole pads but maybe they go the the 7 pin connector? As you can see I'm confused! If anyone here has ever used one of these I'd appreciate any help! __________________ --Sherman

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Volume control on DVD player remote. Lose resolution at low volume?	Circlotron	Digital Source	2	10th June 2011 07:20 PM
Remote volume control for existing remote?	theAnonymous1	Parts	7	6th August 2007 08:22 AM
Remote volume - existing remote	Stuey	Chip Amps	16	25th August 2006 11:44 PM
Remote remote volume	simon dart	Parts	3	7th November 2004 10:00 PM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read

15th September 2005, 01:08 PM	#2
dine1967 diyAudio Member Join Date: Jan 2003 Location: NJ	You can contact them and they will send you the details of connections with a writeup. Let me know if you are unable to get it from them, and I will email you. thanks, Dinesh

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)