Does anyone know of a tube preamplifier which is well documented, easy for diy and that has already been built before? I am searching for some time now to find an article like those published from Mr. Pass, for his series of preamplifiers, but to no avail. Can someone help pointing me in the correct direction.
I have found out about Pete Millett's low-mu preamplifier, from Audioxpress magazine 02/04, but I can not find anyone that has built this preamp nor any reviews. Any comments?
(This preamp can be found at www.pmillett.addr.com)
Thank you
George
I have found out about Pete Millett's low-mu preamplifier, from Audioxpress magazine 02/04, but I can not find anyone that has built this preamp nor any reviews. Any comments?
(This preamp can be found at www.pmillett.addr.com)
Thank you
George
www.diyparadise.com has a 'Simple 5687' tube preamp project. The site is down for me now though.
Bottlehead Foreplay.
Built by many, easy to build, cheap, sounds good (to me), and has great support.
Go to bottlehead.com (i'm not affiliated)
Built by many, easy to build, cheap, sounds good (to me), and has great support.
Go to bottlehead.com (i'm not affiliated)
hmmm, can you expound on what you mean?I believe that's a line-stage not really a full fledged pre-amp...
Sch3mat1c said:Preamp:
Newbie question:
Why are the tubes used for the signal side also found in the PSU side?
hi
only in reference to their filaments.
Federico
Why are the tubes used for the signal side also found in the PSU side?
only in reference to their filaments.
Federico
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Tubes / Valves
- Tube preamplifier