I wanna make bigger amp (20-50 watt) and this amp from Vacuum State :
http://www.vacuumstate.com/images/PP-1C.gif
http://www.vacuumstate.com/images/PP-1C_ps.gif
Does any have built this amp? Can replace El34 with SV6550C?
or may be suggestion about building another good sounding PP amp specially using 6550...
I wanna build this because it has no feedback (which alot of people say it has a bad effect) and it uses plate load on driver....
Help me please...
http://www.vacuumstate.com/images/PP-1C.gif
http://www.vacuumstate.com/images/PP-1C_ps.gif
Does any have built this amp? Can replace El34 with SV6550C?
or may be suggestion about building another good sounding PP amp specially using 6550...
I wanna build this because it has no feedback (which alot of people say it has a bad effect) and it uses plate load on driver....
Help me please...
I have not had good luck with the SV6550C tubes due to premature tube failure. For that reason, I have converted my power amplifier to Sovtek KT88 tubes. I couldn't be happier.
Inverse feedback in push-pull amplifiers is almost always necessary to reduce crossover (notch) distortion and to reduce the output impedance of the amplifier.
Inverse feedback in push-pull amplifiers is almost always necessary to reduce crossover (notch) distortion and to reduce the output impedance of the amplifier.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.